Oven Repair in Naples, FL

An electric oven that does not heat at all usually has a failed bake element. The bake element is the lower heating coil — when it burns out, you can often see a visible break or blister in the coil. We replace bake and broil elements on every brand. On gas ovens, the igniter is the most common failure. The igniter glows to heat up and draw enough current to open the gas safety valve. As igniters age, they glow but do not get hot enough to open the valve — the oven never lights.

An oven that heats but does not reach the correct temperature may have a failing igniter (gas) that opens the valve intermittently, a temperature sensor (thermistor) that is giving inaccurate readings, or a control board that is not regulating the element or burner properly. We use a separate oven thermometer during diagnosis to verify actual cavity temperature against the set point.

On convection ovens, the convection fan and its associated heating element are separate from the bake element. If the convection fan motor fails, convection mode will not work even though standard bake might. We test and replace convection components as needed.

After running a self-clean cycle, the door lock mechanism sometimes fails to unlock. The lock motor or solenoid may have burned out during the high-heat cycle, or the latch may be mechanically stuck. We can usually release the lock and replace the failed component without damaging the door or frame.

An oven door that does not close flush or feels loose typically has broken or worn door hinges. The hinges on wall ovens and ranges take a lot of stress from the heavy door, and the hinge springs can snap. We replace hinges and adjust door alignment. A door that does not seal properly also wastes energy and causes temperature inaccuracy, so this is worth addressing.

GE / GE Profile / Cafe: Bake and broil element failures, igniter replacement on gas models, control board relay burnouts, and temperature sensor faults. GE wall ovens are very common in Naples homes. The convection fan motor and its housing can also develop issues on Profile and Cafe models.

Whirlpool / Maytag / KitchenAid / JennAir: Igniter failure on gas models, bake element burnout, door lock mechanism failure after self-clean, and control board issues. KitchenAid and JennAir share the same platforms with Whirlpool and use common parts.

Samsung / LG: Samsung and LG ovens may develop control board communication errors, temperature sensor faults, and convection fan motor issues. Samsung slide-in ranges are common in newer Naples homes, and we see igniter and sensor issues regularly.

Frigidaire / Electrolux: Bake and broil element failures, temperature sensor issues, and relay failures on the control board are the top repairs. The Electrolux and Frigidaire Professional lines use the same board family.

Bosch / Thermador: Control module failures, igniter issues on gas models, door hinge breakage, and convection motor faults. Thermador Pro Grand and Pro Harmony ranges require brand-specific knowledge that we have.

Wolf / Viking / Dacor: These premium brands require experienced technicians. Common repairs include igniter replacement, thermostat calibration, control board service, and door hinge repair. We handle these high-end units with the care they require.